WKWF Product Installation Instructions
Read below for help with installation.
How to properly install your new Wayde King Water Filtration System
- Connect Inlet/Outlet of system to the water loop or main line to the house. Make sure to identify correctly the Inlet and Outlet of system with the waterline.
- Plumb system drain line.
- Plug-in system and set the time. (See operations manual)
- Turn on the water to the system, make sure the system is in the “Bypass” position (Figure 2)
- Check for water leaks, repair if necessary.
- Regenerate the system.
- Slowly open the inlet side of the bypass and allow water to fill the tank. (Figure 4)
- When water is flowing to drain, close the bypass inlet valve and let the system “soak” the media for 2 hours. (Figure 2)
- Regenerate the system again and slowly open the inlet valve, when water is flowing to drain slowly open the outlet valve. (Figure 1)
- Let the system completely finish its backwash cycle. (It will do it automatically)
- Start enjoying your new King Water Filtration System.